ISO 22632:2019 Adhesives – Test methods for adhesives for floor and wall coverings – Shear test.
This document specifies a test method to measure the adhesion ola resilient or textile floor covering or wall covering bonded to a given substrate under shear forces. The term “wall covering” does not include any type of wallpaper.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 472. Plastics — Vocabulary
ISO 554, Standard atmospheres for conditioning aiid/or testing — Specifications
ISO 7500-1, Metallic materials — Calibration and verification of static uniaxial testing machines — Part 1:
Tension/compression testing machines — C’alibration and verification of tile force-measuring system
ISO 9142, Adhesives — Guide to the selection of standard laboratory ageing conditions for testing
bonded joints
ISO 10365, Adhesives — Designation of main failure patter/is
ISO 15605, Adhesives — Sampling
EN 1067, Adhesives — Examination and preparation of samples for testing
3 Terms and definitions
For the purposes of this document, the terms and definitions given in ISO 472 and the following apply.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
— ISO Online browsing platform: available at https://www.iso.org/obp
— IEC Fiectropedia: available at http://www.e1ectropediaorg/
3.1
covering
flexible resilient or textile floor covering or wall covering
3.2
adhesive for coverings
adhesive which is intended to produce firm and durable bonds between coverings (11) and various substrates
4 Principle
The adhesion is determined by measuring the shear strength under specified conditions before and after storing the bonds at 23 °C/50 °C tinder specified conditions.
5 Apparatus and materials
5.1 Notched trowel (for the shape of the notch, see Figurc1), with dimensions ci, b and c specified by the adhesive manufacturer.
5.3 Heating chamber, ventilated and adjustable to a temperature between 20°C and 200 °C according to Iso 9142.
5.4 Tensile testing machine, conforming to ISO 7500-1, class 1.
5.5 Primer, if applicabic.
5.6 Test covering, five test pieces for each conditioning sequence of dimensions 60 mm x 50 mm,
the long side, running in the machine direction where this can be identified, and shall be taken at least
10 mm from the edge.
5.7 Substrate materials.
Use either fibre cement or plywood as the substrate.ISO 22632 pdf download.