Free Standards Online
IEC 61980-1-2020 Electric vehicle wireless power transfer (WPT) systems – Part 1: General requirements. This part of IEC 61 980 applies to the supply device for charging electric road vehicles using wireless methods at standard supply voltages per IEC 60038 up to 1 000 V AC and up to 1 500 V DC. Electric road vehicles (EV) covers road vehicles, including plug-in hybrid road vehicles (PHEV) that derive all or part of their energy from on-board rechargeable energy storage systems (RESS). This document also applies to wireless power transfer (WPT) equipment supplied from on-site storage systems (e.g. buffer batteries). The aspects covered in this document include • the characteristics and operating conditions of a supply device, • the specification for required level of electrical safety of a supply device, • communication between EV device and vehicle to enable and control WPT, • efficiency, alignment and other activities to enable WPT, and • specific EMC requirements for a supply device. The following aspects are under consideration for future documents: • requirements for MF-WPT systems supplying power to EVs in motion; • requirements for bidirectional power transfer. This document does not apply to: • safety aspects related to maintenance, • WPT system for trolley buses, rail vehicles and vehicles designed primarily for use off‑road, and • any safety or EMC requirements for the vehicle side. 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. IEC 60038, IEC standard voltages IEC 60068-2-1 , Environmental testing – Part 2 ‑ 1: Tests – Test A: Cold IEC 60068-2-2, Environmental testing – Part 2 ‑ 2: Tests – Test B: Dry heat IEC 60068-2-5, Environmental testing – Part 2 ‑ 5: Tests – Test S: Simulated solar radiation at ground level and guidance for solar radiation testing and weathering IEC 60068-2-1 1 , Basic environmental testing procedures – Part 2 ‑ 11: Tests – Test Ka: Salt mist IEC 60068-2-30, Environmental testing – Part 2 ‑ 30: Tests – Test Db: Damp heat, cyclic (12 h + 12 h cycle) IEC 60068-2-78, Environmental testing – Part 2-78: Tests – Test Cab: Damp heat, steady state IEC 60085, Electrical insulation – Thermal evaluation and designation...

Download Address

  • Download