BS EN IEC 63171-1-2020 Connectors for electrical and electronic equipment Part 1: Detail specification for two-way, shielded or unshielded, free and fixed connectors一Mechanical mating information, pin assignment and additional requirements for Type 1 copper LC style

BS EN IEC 63171-1-2020 Connectors for electrical and electronic equipment Part 1: Detail specification for two-way, shielded or unshielded, free and fixed connectors一Mechanical mating information, pin assignment and additional requirements for Type 1 copper LC style. This part of IEC 63171 covers two-way, shielded or unshielded, free and fixed connectors for data transmission with frequencies up to 600 MHz and with current carrying capacity up to 2,0 A at 60 °C. It is intended to specify the common dimensions, mechanical, electrical, signal integrity, environmental characteristics, reliability specifications and corresponding tests for these connectors. 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the reference document (including any amendments) applies. IEC 60050-581, International Electrotechnical Vocabulary (1EV) — Chapter 581:Electromechanical components for electronic equipment IEC 60068-1, Environmental testing — Part I: General and guidance IEC 60512-1, Connectors for electrical and electronic equipment — Tests and measurements — Part 1: Generic specification IEC 60512-1-1, Connectors for electronic equipment — Tests and measurements — Part 1-1:General examination — Test Ia: Visual examination IEC 60512-1-2, Connectors for electronic equipment — Tests and measurements Part 1-2:General examination — Test Ib: Examination of dimension and mass IEC 60512-2-1, Connectors for electronic equipment — Tests and measurements — Part 2-1:Electrical continuity and contact resistance tests — Test 2a: Contact resistance — Millivolt level method IEC 60512-2-5, Connectors for electronic equipment — Tests and measurements — Part 2-5:Electrical continuity and contact resistance tests — Test 2e: Contact disturbance IEC 60512-3-1, Connectors for electronic equipment — Tests and measurements — Part 3-1: Insulation tests — Test 3a: Insulation resistance IEC 60512-4-1, Connectors for electronic equipment — Tests and measurements — Part 4-1:Voltage stress tests — Test 4a: Voltage proof IEC 60512-5-2, Connectors for electronic equipment — Tests and measurements — Part 5-2:Current-carrying capacity tests — Test 5b: Current-temperature derating IEC 60512-6-4, Connectors for electronic equipment — Tests and measurements — Part 6:Dynamic stress tests — Section 5: Test 6d: Vibration (sinusoidal) IEC 60512-9-1. Connectors for electronic equipment — Tests and measurements — Part 9-1:Endurance tests — Test 9a: Mechanical operation IEC 60512-11-7, Connectors for electronic equipment — Tests and measurements — Part 11-7:Climatic tests — Test I Ig: Flowing mixed gas corrosion test IEC 60512-11-12, Connectors...