Free Standards Online
AS NZS 61058.1.1:2021 Switches for appliances Part 1.1: Requirements for mechanical switches (IEC 61058-1-1:2016 (ED.1.0) MOD). This clause of part 1 is applicable. Add the following at the end of Clause 1. This part of IEC 61058 applies to mechanical switching devices and shall be used in conjunction with the requirements of IEC 61058-1. NOTE Additional requirements for particular switches may be found in the relevant part 2 of IEC 61058. 2 Normative references This clause of part 1 is applicable. 3 Terms and definitions This clause of part 1 is applicable. 4 General requirements This clause of part 1 is applicable. 5 General information on tests This clause of part 1 is applicable with the following addition. Add the following at the end of 5.3. Table 101 provides information on: — The minimum number of specimens needed for each test. — The minimum number of total specimens, when applicable tests are added, needed for each evaluation. — Additional specimens that may be required as a result of additional electrical rating, unique construction or damage/breakage during testing. 6 Rating This clause of part 1 is applicable. 7 Classification This clause of part 1 is applicable. 8 Marking and documentation This clause of part 1 is applicable. 9 Protection against electric shock This clause of part 1 is applicable. 10 Provision for earthing This clause of part 1 is applicable. 11 Terminals and terminations This clause of part 1 is applicable. 12 Construction This clause of part 1 is applicable. 13 Mechanism This clause of part 1 is applicable. 14 Protection against ingress of solid foreign objects, ingress of water and humid conditions This clause of part 1 is applicable. 15 Insulation resistance and dielectric strength This clause of part 1 is applicable. 16 Heating This clause of part 1 is applicable. 17 Endurance Replace the existing text by the following: 17.1 General requirements 17.1.1 Switches shall withstand without excessive wear or other harmful effect the electrical, thermal and mechanical stresses that occur in normal use. 17.1.2 The sequence of tests to be completed on the same 3 specimens is as follows: — TC3: a test at high speed specified in 17.5.3; this test only applies to switches with more than one pole, and where the type of connection is of polarity reversal; — TC2: a test at slow speed specified in 17.5.2, — TCI: an increased-voltage test at accelerated speed...

Download Address

  • Download