UL 62841-2-11:2017 Electric Motor-Operated Hand-Held Tools, Transportable Tools And L _awn And Garden Machinery一Safety 一Part 2-11: Particular Requirements For Hand-Held Reciprocating Saws

UL 62841-2-11:2017 Electric Motor-Operated Hand-Held Tools, Transportable Tools And L _awn And Garden Machinery一Safety 一Part 2-11: Particular Requirements For Hand-Held Reciprocating Saws. This clause of Part 1 is applicable except as follows: Addition: This part of IEC 62841 applies to hand-held reciprocating saws such as jig saws and sabre saws. 2 Normative references This clause of Part 1 is applicable except as follows: Addition: ISO 16893-1:2008, Wood based panels — Particleboard — Part 1: Classifications 3 Terms and definitions This clause of Part 1 is applicable except as follows: Additional definitions: 3.101 reciprocating saw: tool intended for cutting various materials with a blade or blades acting in a reciprocating or oscillating motion 3.102 jig saw: reciprocating saw with a base plate that may allow bevel adjustments Note 1 to entry: Typical designs of jig saws are shown in Figure 102. 3.103 sabre saw: reciprocating saw with a guide plate that may allow tilting movements Note 1 to entry: TypIcal designs of sabre saws are shown in FIgure 103. 4 General requirements This clause of Part 1 is applicable. 5 General conditions for the tests This clause of Part us applicable except as follows 5.17 Addition: The mass of the tool includes the dust extraction adapter, if any. 6 Radiation, toxicity and similar hazards This clause of Part 1 is applicable. 7 Classification This clause of Part 1 is applicable. 8 Marking and instructions This clause of Part 1 is applicable except as follows: 8.14.1 Addition: For reciprocating saws, the additional safety instructions as specified in 8.14.1.101 shall be given. This part may be printed separately from the “General Power Tool Safety Warnings”. 8.14.1.101 Safety instructions for reciprocating saws Hold the power tool by insulated gripping surfaces, when performing an operation where thc cutting accessory may contact hidden wiring or its own cord. Cutting accessory contacting a “live’ wire may make exposed metal parts of the power tool “live” and could give the operator an electric shock Use clamps or another practical way to secure and support the workpiece to a stable platform. Holding the workpiece by hand or against your body leaves it unstable and may lead to loss of control. NOTE The above warning is not applicable for garden saws for tree or hedge services. 8.14.2 b) Addition: 101) Instruction on the correct use of the dust collection system, if any; 102) Information regarding the cutting capacity; 103) Instruction...