AS NZS 2161.2:2020 Occupational protective gloves Part 2: General requirements and test methods (ISO 21420:2020, MOD).
This document specifies the general requirements and relevant test procedures for glove design and construction, innocuousness, comfort and efficiency, as well as the marking and in formation supplied by the manufacturer applicable to all protective gloves.
It can also apply to arm protectors and gloves permanently incorporated in containment enclosures.
Gloves and hand protectors such as mittens, pot holders and arm protection are covered by this document.
This document does not address the protective properties of gloves and therefore is not used alone but only in combination with the appropriate specific standard(s). A non-exhaustive list of these standards is given in the Bibliography.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
Iso 3071, Textiles — Determination of pH of aqueous extract
ISO 3758, Textiles — Care labelling code using symbols
ISO 4045:2018, Leather — Chemical tests — Determination of pH and difference figure
ISO 7000:2014, Graphical symbols for use on equipment — Registered symbols
ISO 11092, Textiles — Physiological effects — Measurement of thermal and water-vapour resistance under steady-state conditions (sweating guarded-hotplate test)
ISO 14268, Leather — Physical and mechanical tests — Determination of water vapour permeability
ISO 14362-1, Textiles — Methodsfordetermination of certain aromatic amines derived from azo colorants — Part 1: Detection of the use of certain azo colorants accessible with and without extracting the fibres
ISO/TS 16190, Footwear — Critical substances potentially present in foot wear and foot wear components — Test method to quantitatively determine polycyclic aromatic hydrocarbons (PA H) in footwear materials
ISO 17075-1, Leather — Chemical determination of chromium(VI) content in leather — Part 1: Colorimetric method
ISO 17075-2, Leather — Chemical determination of chromium(VI) content in leather — Part 2:Chromatographic method
ISO 17234-1, Leather — Chemical tests for the determination of certain azo colorants in dyed leathers — Part 1: Determination of certain aromatic amines derived from azo colorants
150 20344:2011, Personal protective equipment — Test methods for foot wear
ISO 23388, Protective gloves against mechanical risks.AS NZS 2161.2 pdf download.