AS ISO 6392.1:2021 Earth-moving machinery一 Lubrication fittings Part 1: Nipple type.
This part of ISO 6392 specifies nipple-type lubrication fittings, for the types of earth-moving machinery
defined in ISO 6165, and the space required to service these fittings.
NOTE — The lubrication fittings are hereinafter referred to as fittings.
2 Normative references
The following standards contain provisions which, through reference in this text, constitute provisions of this part of ISO 6392. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this part of ISO 6392 are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. Members of IEC and ISO maintain registers of currently valid International Standards.
ISO 208 1:1986, Metallic coatings — Electroplated coatings of zinc on iron or steel. ISO 6165:—i), Earth-moving machinery — Basic types — Vocabulary.
3 Description
Fittings for earth-moving machinery shall be of the types shown in figure 1.
4 Material, design and manufacture
4.1 Material
Unless otherwise specified, fittings shall be made from manufacturer’s standard steel.
4.2 Hardness
Fittings used where there is a high frequency of greasing and/or direct contact with soil or sand shall have their heads surface hardened. In cases where surface-hardening is required, the minimum hardness shall be 83 HRA or 55 HR3ON and shall have a minimum case depth of 0,10 mm. Where surface-hardened heads are not required, hardness is not specified in general.
4.3 Finish
Bodies of fittings shall be electroplated with zinc and chromate treatment in accordance with ISO 2081. The thickness of the coating shall be at least 5 lIm.
4.4 Workmanship
Fittings shall be free from burrs, loose scale, sharp edges, and any other defects that might affect their intended function.
4.5 Check valve
Fittings shall be supplied with check valves which will provide a seal against the ingress of foreign material, but will admit lubricant under pressure and prevent its escape.
5 Shape, dimensions and tolerances
The shape, dimensions and tolerances of fittings shall conform to the requirements given in figures 1 and 2. and table 1. The tabulated dimensions shall apply to the finished processed parts.
6 Proof pressure of fittings
Fittings shall accept grease injection at an injection pressure of up to 20 MPa.
7 Required ambient space at the mounting position of fittings
The required ambient space is such that a grease-gun nozzle, with 18 mm outer diameter, and its extension can be inclined to a minimum angle of 25° in one direction (see figure 3).AS ISO 6392.1 pdf download.