AATCC 204-2015 Colorfastness to Burnt Gas Fumes.
3. Terminology
3.1 burnt gas fumes, n.—atmospheric oxides of nitrogen as derived from the combustion of illuminating or heating gas.
3.2 colorfastness, n.—the resistance of a material to change in any of its color characteristics, to transfer of its colorant(s) to adjacent materials, or both, as a result of the exposure of the material to any environment that might be encountered during the processing, testing, stor- age or use of the material.
4. Safety Precautions NOTE: These safety precautions are for information purposes only. The precautions are ancillary to the testing procedures and are not intended to be all inclusive. It is the user’s responsibility to use safe and proper techniques in handling materials in this test method. Manufacturers MUST be consulted for specific details such as material safety data sheets and other manufacturer’s recommenda- tions. All OSHA standards and rules must also be consulted and followed.
4.1 Good laboratory practices should be followed. Wear safety glasses in all laboratory areas.
4.2 All chemicals should be handled with care.
4.3 Stoddard solvent is a combustible liquid and presents a moderate hazard. It should not be used near an open flame, and fabric saturated with this solvent should be dried in an adequately ventilated laboratory hood. Use chemical gog- gles or face shield, impervious gloves and an impervious apron when handling Stoddard solvent.
4.4 Perchloroethylene is toxic by inha- lation, by repeated contact with skin and by ingestion; it MUST be used only in a well vented atmosphere. Toxicology studies with laboratory animals have shown evidence of cancer in rats and mice exposed to perchloroethylene vapors at 100-400 ppm concentrations for prolonged times. Fabric saturated with this solvent should be dried in an ade- quately ventilated laboratory hood. Use chemical goggles or face shield, impervious gloves and an impervious apron when handling perchloroethylene.
4.5 An eyewash/safety shower should be located nearby and an organic vapor respirator should be readily available for emergency use.
4.6 In previous versions of this test, recommendations were made for the use of a wire screen placed above the burner to decrease the test time. During recent studies it was found that the improper application of the steel screen may increase the generation of residual unburnt gas and, thereby, cause the potential for an explosion. The manufacturers of the de- vices are recommending against the use of this screen due to potential safety is- sues (see 11.6.1).AATCC 204 pdf download.